Loewe Individual 32 Compose Sound LED Operating Instructions Manual page 23

Initial installation
Selecting
INITIAL INSTALLATION
antennas
Connect antenna cable(s)
Antenna cable(s) for:
Antenna/cable (analogue)
DVB-T
DVB-C
Proceed
OK
Select antenna cable.
Yellow button: Connect/disconnect antenna cable.
Antenna/cable (analogue): analogue stations via
DVB-T:
DVB-C:
DVB-S (cable 1):
DVB-S (cable 2):
The selection options for the aerials depend on the
receiver units installed or upgraded at the factory (see
also page 146).
Depending on which antenna(s) was (were) selected, the
appropriate settings are called later during the routine.
OK Proceed.
Subtitle and
INITIAL INSTALLATION
audio
Subtitle and audio languages (DVB)
Favoured subtitle language
languages
Alternative subtitle language
(DVB) Favoured audio language
Alternative audio language
Audio commentary
Proceed
OK
Select desired languages and alternative
languages for subtitles and audio for DVB
programmes (see page 61).
Set up audio commentary for the visually
impaired (see page 43).
OK Proceed.
Depending on which antennas (DVB-T, DVB-C, DVB-S)
were selected, the appropriate settings appear
below.
to antenna socket(s):
ANT TV
ANT TV
ANT TV
Connect/disconnect
Back
cable/antenna
digital terrestrial stations
digital stations via cable
digital stations via satellite
digital stations via satellite
English ...
OK
German
English
German
off
Back
Setting options for DVB-T reception:
If you have not selected a DVB-T antenna in the antenna selection: Con-
tinue with setting options for DVB-C reception on page 24.
Network If several networks are available over DVB-T, you can
selection decide which network you want to receive your channels
from.
Select network,
OK Proceed.
Settings
INITIAL INSTALLATION (DVB-T)
Scrambled stations
Search method
Proceed
OK
Select and adapt settings for DVB-T reception.
Encrypted You can state whether coded stations are to be searched
stations for in the search/update. Select yes to save all found
scrambled stations. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card. Handling of the CA module is
described on page 63.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
Search If you want to run the station search independently of
method the channel grid, select frequency search for the search
method.
OK Proceed.
Supply voltage
INITIAL INSTALLATION (DVB-T)
Antenna
Supply voltage
no (0V)
Proceed
OK
Select supply voltage no / yes.
Use a DVB-T antenna that requires a supply voltage
(active antenna) and which is not already supplied
via a power adapter, then select yes (5V) for the
antenna's power supply.
How to align your DVB-T antenna is described on
page 33.
OK Proceed.
no yes
Channel search
yes (5V)
OK
Back
23 -