Napoleon ultra chef 485 series User Manual page 22

22
4 x N570-0091 (1/4-20 X 1/2")
9. Grill Head Installation
L485RSIB MODELS -
remove the zip tie holding the wire connectors in place. (Take care when removing the tie not to damage the wires).
Ensure the wires drop inside the cart and do not become pinched between the grill head and the cabinet when mounting
the grill head.
PROPANE ONLY -
To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator
up under control panel. This was installed at the factory to protect the regulator hose during shipping and is no longer
required. (Take care when removing the tie not to damage the hose). Ensure the regulator drops into the small opening,
between the tank heat shield and the right side of the cabinet.
Lift grill head and place on assembled cart, lining up holes in top of side cart panels with holes in bottom of base. Fasten
from inside using (4) 1/4-20 x 1/2" screws, two per side.
Two people are required for this step.
Correct Assembly
www.ultrachefgrills.com
Are equipped with internal lights. To avoid assembly difficulties, prior to mounting grill head
Incorrect Assembly
3/8"(10mm)