Switching Off; Changing The Dust Bag - Morphy Richards BAGGED CYLINDER VACUUM CLEANER Instructions Manual

Bagged cylinder vacuum cleaner
Hide thumbs Also See for BAGGED CYLINDER VACUUM CLEANER:
Table of Contents

Advertisement

73277 rev1:VC73277 MUK Rev 1 23/04/2009 10:02 Page 6
F
G
H
I
J
K
L
UK Helpline 0844 871 0949
6
Tube standby
F
During short breaks in cleaning,
the tubes can be held in an
upright, 'standby' position ‰,
whilst you move furniture for
instance.
IMPORTANT: Ensure that the
appliance is never left
unattended whilst it is switched
on.

Switching off

G
Switch off the appliance.
Remove the plug from the
mains supply and rewind the
power cable using the cable
rewind switch ·.
WARNING: When using the
cable rewind, always hold the
plug as the cable will rewind
quickly.
STORAGE
Tube park
H
The vacuum cleaner can be
stored in an upright position.
Rotate the floor nozzle until the
lug on the neck can be fitted
into the tube park slot Ê on the
base of the appliance.
MAINTENANCE
DUSTBAG
Changing the
dustbag
If suction power is reduced or if
the 'dustbag full' indicator ‡ is
permanently fully red, the
dustbag needs changing. Also,
check whether the suction hose,
tube or nozzle are blocked.
To access the dustbag, press
the dust compartment release
lever ¤ to open the cover I.
Replacement Parts 0844 873 0715
1
Pull the tab on the dustbag to
one side so that the opening is
hygienically sealed.
2
Pull out the dustbag holder È
and dustbag in an upward
direction J.
3
Pull the bag Ë sideways out of
the holder È K.
4
Dispose of the bag with your
household waste.
5
Insert a new dustbag in the
holder.
6
Replace the dustbag holder and
close the cover.
IMPORTANT: If a dustbag is not
fitted, the cover will not close.
This is a safety feature.
FILTERS
Changing/cleaning
the motor protection
filter
The motor protection filter is
accessible from the dust
compartment only when the
dustbag has been removed first.
IMPORTANT: Never use the
appliance without the motor
protection filter installed,
otherwise damage to the motor
may occur which would not be
covered by the guarantee.
1
Slide the filter cover ‹ upwards
to remove L.
2
Take out the filter and clean (by
shaking) or wash L.
3
To wash the filter, gently wash in
warm water and leave to air dry.
Do not use detergents. Ensure
the filter is fully dry before
replacing into the machine.
4
Slide the filter holder back into
position.
IMPORTANT: Check this filter
every time the dustbag is
replaced and clean if necessary.
Ireland Helpline 1800 409 119

Advertisement

Table of Contents
loading

This manual is also suitable for:

73277

Table of Contents