Table of Contents
Advertisement
VC732102 MUK Rev1.qxp_Instruction Book 14/11/2016 09:28 Page 8
Tool storage
When not in use, the attachments may be stored
on the storage / charging mount
below.
The storage / charging mount should already be
fitted to the wall (see 'Charging / storage mount
fitting' page 5).
Maintenance
WARNING: Always remove the handheld
vacuum cleaner from the main vacuum cleaner
body and the mains adaptor from the mains
supply before undertaking any maintenance or
cleaning procedures.
Your cleaner is manufactured to withstand normal
day-to-day use, but an occasional wipe over with
a damp cloth will help maintain its good looks.
Take care not to get the electrical connections wet.
Abrasive cleaners should not be used.
8
Maintenance - emptying
the dust canister
(6)
as shown
Empty the dust canister
not look full, this will maintain the performance.
Remove the handheld vacuum cleaner
1.
the main vacuum cleaner body
'Handheld vacuum cleaning', page 7).
Press the dust canister release buttons
2.
pull the dust canister away from the handheld
vacuum cleaner.
Remove the dust canister filter holder assembly
3.
(18)
canister. Care should be taken not to release the
dust until over a bin.
At the same time, ensure the top and bottom areas
of the cyclone cone
are cleaned and free from dust or other debris.
It is recommended that the individual parts of the
4.
dust canister filter holder assembly
the pleated filter 18b) (see image 3 on page 9)
are brushed or tapped clean before refitting on
each empty of the dust canister (to access, see
'Maintenance - filter' section). In addition, they
must be washed monthly as instructed in the
'Maintenance - filter' section.
Fit all parts of the dust canister filter holder
5.
assembly
the dust canister (17), then replace the dust
canister back onto the handheld vacuum cleaner.
Replace the handheld vacuum cleaner
6.
into the main vacuum cleaner body
cleaning.
(17)
regularly even if it does
and empty the dirt from inside the dust
(18a) (see image 3 on page 9 )
(18)
back together, then refit back into
(10)
from
(11)
(see
(19)
and
1
2
18
(18 - including
(10)
back
(11)
if upright
Hide quick links:
Advertisement
Table of Contents
