Table of Contents
Advertisement
VC732008MUK Rev2.qxp_Instruction Book 06/10/2015 09:21 Page 6
Emptying the dust canister
Empty the dust canister
does not look full, this will maintain the
performance.
Press the dust canister release button
1.
the dust canister away from the vacuum cleaner
body (4).
Remove the dust canister filter
2.
dirt from inside the dust canister.
If the filter
(7)
is not washed as instructed in the
3.
'Maintenance - filter' section, it is recommended
that the filter is brushed or tapped clean before
refitting on each empty of the dust canister.
Replace the filter into the dust canister by
4.
aligning the arrow on the dust canister with the
arrow on the filter. Push the filter down securely
into the dust canister. Ensure the rectangular inlet
on the side of the filter's lower section aligns with
the rectangular hole on the side of the dust
canister.
Replace the dust canister back into the vacuum
5.
cleaner body (4).
6
(6)
regularly even if it
(5)
and pull
5
(7)
and empty the
Maintenance
WARNING: Always remove the charger from the
mains supply and the floorhead from the
vacuum cleaner body before undertaking any
maintenance or cleaning procedures.
Your cleaner is manufactured to withstand normal
day-to-day use, but an occasional wipe over with
a damp cloth will help maintain its good looks.
Take care not to get the electrical connections
wet.
Abrasive cleaners should not be used.
Maintenance - filter
The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filters installed; not cleaning the filters; or
not replacing a damaged filter.
Cleaning the dust canister filters
To maintain suction, the dust canister filters
must be cleaned each time the dust canister
is emptied.
Follow steps 1-3 of 'Emptying the dust canister'.
1.
Pull the pleated filter
(7c)
2.
canister filter (7). There is an additional foam filter
(7b)
between the cyclone cone
pleated filter - this must also be removed.
7a
Every month, wash the foam filter
3.
pleated filter
(7c)
in luke-warm water and
thoroughly air dry before re-fitting.
IMPORTANT: Do not wash the filters with hot
water or detergents.
IMPORTANT: Do not use heated appliances to
dry the filters.
Return the foam filter into the pleated filter and
4.
push the pleated filter back into the dust canister
filter.
Replace the filters into the dust canister
5.
replace the dust canister back into the vacuum
cleaner body (4).
(6)
away from the dust
(7a)
and the
7b
7c
(7b)
and the
(6)
then
Advertisement
Table of Contents
