Table of Contents
Advertisement
S
etting Up the Audio Options
1
1
With no disc playing, press the SETUP
AUDIO OPTIONS
button.
1 Digital Output
PCM
2 DTS
Off
2
Use the UP/DOWN button to select AUDIO
2
3 Dynamic Compression
On
OPTIONS. Then press the ENTER button.
4 2X Scan Audio
Off
5 Speaker setup
3
Use the UP/DOWN button to select the
3
desired item. Then press the LEFT/RIGHT
RETURN
button.
DIGITAL OUTPUT
1
PCM : Converts to PCM(2CH)
2
BITSTREAM : Converts to Dolby
NOTE : Be sure to select the correct Digital
Output or no audio will be heard.
DTS
ON : Outputs DTS BITSTREAM via digital
1
2
OFF : Doesn't output digital signal.
DYNAMIC COMPRESSION
1
ON : To select dynamic compression.
OFF : To select the standard range.
2
2X SCAN AUDIO
1
ON : Turns 2X audio on.
2
OFF : Turns 2X audio off.
NOTE
Though 2X SCAN AUDIO is ON in the
SETUP MENU, no sound will be heard on
• How to make the SETUP
discs which are recorded with LPCM, DTS or
MENU disappear or
MPEG-2.
return to menu screen
SPEAKER SETUP
during set up;
Press RETURN button.
• Certain audio features of this product manufactured under a license from Desper
®
Products, Inc. Spatializer
and circle-in-square device are trademarks owned by Desper
Products, Inc.
• Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are
trademarks of Dolby Laboratories. Confidential unpublished works. ©1992-1997 Dolby
Laboratories Inc. All rights reserved.
• "DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems, Inc.
30
48kHz/16Bit audio. Select PCM when
using the Analog Audio Outputs.
Digital BITSTREAM (5.1CH).
Select BITSTREAM when
using the Digital Audio Output.
output only. Select DTS when connecting
to a DTS DECODER.
S
urround Sound Speaker Setup
1
Press the SETUP button in play or stop
1
SPEAKER SETUP
mode.
2
3
4
1
5
2
Press the UP/DOWN button to select
2
AUDIO OPTIONS. Then press the ENTER
6
7
TEST
button.
8
12
3
9
10 11
Use the UP/DOWN button to select SPEAK-
3
ER SETUP . Then press the ENTER button.
RETURN
ENTER
4
Use the UP/DOWN or LEFT/RIGHT button
4
to select the desired item.Then press the
1. Speaker Mode(Front L)
2. Channel Balance(Center)OdB
ENTER button.
3. Speaker Mode(Center)
4. Delay Time(Center)Oms
Setting up SPEAKER MODE
5. Speaker Mode(Front R)
• If you have connected the system to a speaker with low frequencies of
6. Channel Balance(Subwoofer)OdB
7. Speaker Mode(Subwoofer)
100Hz or below, select 'Found(Large illustration)'.
8. Speaker Mode(Surround L)
• If you have connected the system to a speaker without low frequencies of
9. Channel Balance(Surround L)OdB
100Hz or below, select 'Found(Small illustration)'. If you don't connect a
10. Delay Time(Surround L/R)Oms
subwoofer, always select 'Found(Large illustration)' for the Front
11. Channel Balance(Surround R)OdB
Speakers(L/R).
12. Speaker Mode(Surround R)
• When you don't have a particular speaker connected, select 'Not found(No
illustration visible)'.
Setting up DELAY TIME
• When 5.1CH Surround Sound is played, you can enjoy the best sound if
the distance between you and each speaker is the same. You can set
Ideal CENTER SPEAKER position
Delay Time in the Center/Surround Speaker to customize the sound to the
acoustic of your room.
• Arrange all
speakers
within circle.
• Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than the distance of Df in the left
figure, set the mode as Oms. Otherwise, change the setting according to
the table below.
(A) = Df - Dc
Distance of (A)(in) Setting(ms)
1.64
Ideal SURROUND SPEAKER position
3.28
4.92
6.56
NOTE
• Setting SURROUND SPEAKERS
• How to make the SETUP
If the distance of Df is equal to the distance of Ds in the above, set the
mode as Oms. Otherwise, change the setting according to the table on the
MENU disappear or
right.
return to menu screen
(B) = Df - Ds
during set up.
Distance of (B)(in) Setting(ms)
Press RETURN button.
6.56
• The subwoofer test output
13.12
signal is lower than the
19.68
other speakers.
Setting up TEST
• The MPEG Multichannel
The test output signals come clockwise starting from the Front
logo is a trademark regis-
Speaker(L). Adjust Channel Balance to match to the volume of test
tered by PHILIPS
signals memorized in the system.
Corporation.
FRONT(L)
SURROUND(R)
1.3
2.6
3.9
5.3
5.3
10.6
15.9
CENTER
FRONT(R)
SUBWOOFER
SURROUND(L)
31
Advertisement
Table of Contents
