Lexmark E350d Menus And Messages Manual page 32

Message
39 Complex Page
42 Cartridge Region Mismatch
50 PPDS font error
51 Defective flash
52 Flash full
53 Unformatted flash
54 Std network software error
55 Unsupported flash in slot <x>
56 Std parallel port disabled
56 Standard USB port disabled
56 Standard USB port disabled
58 Too many flash options
Understanding printer messages
Action
The page may not print correctly because the print information on the page is too
complex.
• Press to clear the message and continue printing the job. The job may not print
correctly.
• Press to open the Job Menu and cancel the current job.
• To avoid this error in the future:
– Reduce the complexity of the page by reducing the amount of text or graphics on
the page and deleting unnecessary downloaded fonts or macros.
– Set Page Protect to On in the Setup Menu.
– Install additional printer memory.
The geographic region of the printer does not match the geograhpic region of the
installed toner cartridge. Remove the toner cartridge and install a new cartridge that
matches the region of the printer.
• To clear the message and continue printing, press
The job may not print correctly.
• Cancel the current job.
To clear the message and continue printing, press
You must install different flash memory before you can download any resources to
flash.
• To clear the message and continue printing, press
Downloaded fonts and macros not previously stored in flash memory are deleted.
• Delete fonts, macros, and other data stored on the flash memory.
• Install a larger capacity flash memory card.
To clear the message and continue printing, press
You must format the flash memory before you can store any resources on it. If the
error message remains, the flash memory may be defective and require replacing.
• To clear the message and continue printing, press
The job may not print correctly.
• Program new firmware for the network interface.
• Reset the printer.
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option.
4 Plug in the power cord.
5 Turn the printer on.
• To clear the message, press
• The printer discards any data received through the parallel port.
• Make sure the Parallel Buffer menu item is not set to Disabled.
• To clear the message, press
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
• To clear the message, press
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu item is not set to Disabled.
1 Turn off and unplug the printer.
2 Remove the excess flash memory.
3 Plug in the printer, and turn it on.
32
.
.
.
.
.
.
.
.