Lexmark E350d Menus And Messages Manual page 10

Universal Setup
This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal
Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up.
Menu selection Purpose
Units of Measure Determines the unit of measure used to
enter the Universal Height and Width
Portrait Width Sets the portrait width of the universal
media
Note: If the value set exceeds the
maximum width, the printer will use the
maximum value allowed in inches or
millimeters.
Portrait Height Sets the portrait height of the universal
media
Note: If the value set exceeds the
maximum height, the printer will use the
maximum value allowed in inches or
millimeters.
Feed Direction Specifies the feed direction
Substitute Size
This menu selection is used to determine whether the printer can substitute another size paper if the requested paper size is not currently
installed in any of the printer input sources. If, for example, Substitute Size is set to Letter/A4, and only letter size paper is installed in the
printer. When a request is received to print on A4 paper, the printer will substitute letter for A4 and print the job instead of displaying a
change paper request.
Menu selection Purpose
Substitute Size Substitutes the specified paper size if
the requested size is not loaded
Paper Texture
This menu selection is used to set the media texture for each of the defined media types. This allows the printer to optimize the print
quality for the specified media.
Menu selection Purpose
Plain Texture Identifies the texture of the media loaded
in a specific input source
Card Stock Text Identifies the texture of the card stock
loaded in a specific input source
Using printer menus
Values
Inches
Millimeters
3 inches to 14.17 inches
in 0.01 inch increments
76 mm to 360 mm in
1 mm increments
3 inches to 14.17 inches
in 0.01 inch increments
76 mm to 360 in 1 mm
increments
Short Edge*
Long Edge
Values
Off
Statement/A5
Letter/A4
All Listed*
Values
Smooth
Normal*
Rough
Smooth
Normal*
Rough
10
Inches is the US default; Millimeters is the
international default.
Shows either inches or mm from Units of
Measure setting; 11.69 inches is the US
default, and 297 mm is the international
default.
Shows either inches or mm from Units of
Measure setting; 17 inches is the US
default, and 432 mm is the international
default.
Long Edge is only shown if the longest
edge is shorter than the Maximum Physical
Width of the printer.
The All Listed value indicates that all
available substitutions are allowed.
Shown if Card Stock is supported in the
specified input source