Using The Adjustment Program; Top Margin Adjustment - Epson Stylus NX100 Service Manual

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119

5.2 Using the Adjustment Program

This section describes how to judge the adjustment patterns printed by the Adjustment
Program. For information on how to operate the Adjustment Program, see the
instructions displayed by the Adjustment Program.

5.2.1 TOP Margin Adjustment

Three adjustment patterns are printed on the top of the paper as shown in
How to Judge
Within ±3 steps from
standard line is OK
1 Step
Figure 5-1. Top Margin Adjustment Printout Pattern
How to Judge
Check if the top edge of the paper is within -3 to +3 steps from the standard line.
Additional Information
If it is not within the OK range, select the adjustment value (-4 to +4 steps) on the
adjustment program to adjust the top edge of paper until it becomes within -3 to +3
steps from the standard line. Then, print the adjustment pattern again to check the
result.
ADJUSTMENT
Figure 5-1.
NG:-4 steps from
standard line
OK
Standard line
OK
NG:+5 steps from
standard line
Position of the top edge of paper
Using the Adjustment Program
The patterns are printed on three sections. If those three patterns
C H E C K
are in different position to the top edge of paper, the paper was
P O I N T
fed on a skew. Set the papers correctly and print it again to
adjust the top margin correctly.
The following pattern is printed with the optimal adjustment
value.
Top edge of paper
Revision C
Standard line
115
Confidential