Mounting The Hitch To The Debris Blower - Toro Pro Force 44553 Operator's Manual

DANGER
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes severe
burns.
• Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
2. Attach the positive cable (red cable) to the positive (+)
terminal.
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
3. Attach the negative cable (black cable) to the negative
(-) terminal of the battery.
4. Coat the terminals and mounting fasteners with
petroleum jelly to prevent corrosion.
5. Install the battery cover and secure with the clips.
2
Mounting the Hitch to the
Debris Blower
Parts needed for this procedure:
1 Debris blower assembly
1 Hitch
2 Bolt (3/8 x 3 inches)
2 Flange nut (3/8 inch)
Procedure
1. Position the debris blower on a flat, level surface.
2. Insert the hitch tube into the frame brackets
5). Secure the tube to the frame with 2 bolts (3/8 x 3
inches) and flange nuts (3/8 inch).
1. Frame brackets
3. Route the wire harness along the right side of the hitch
tube (Figure
1
1. Wire harness
4. Plug the harness clips into the holes in the side of the
hitch tube to secure it
5. Store the harness connector in the hitch tube holster
(Figure
(Figure
9
1
2
G020731
Figure 5
2. Hitch tube
6).
2
Figure 6
2. Harness clips
(Figure 6).
7).
G020732