Table of Contents
Advertisement
Available languages
Available languages
2
INSTALLATION TEST
• Turn water supplies on and check for leaks.
• Using your finger touch the Rim (Grey shaded area) (1)
to switch between different modes.
2a
REMOTE FUNCTIONALITY TEST (OPTIONAL)
• Press on Button (1) to switch between different modes.
3
SERVICE
• Clean the Nozzles on the shower head by massaging each nozzle
using your finger.
• Clogged nozzles can also be cleaned using toothbrush. Dip the
toothbrush in vinegar and gently rub the nozzles with dipped
toothbrush. Turn the shower on and let the water run for some
time to clear the vinegar out.
BATTERY NEEDS REPLACEMENT:
For Shower Head
• When battery is low, the shower head will switch to the drench
function and touch and/or remote function will stop working.
• Push Button (1) forward and pull the tray out. Replace the batteries
and place the tray back in. (Note: Make sure to push the tray in until
you hear a click.)
• Replace batteries in battery holder with Qty (3) AA alkaline type
batteries.
• Always change all 3 batteries. Failure to replacing all 3 batteries at
the same time may cause electronics to not work properly.
• Battery lifetime is approximately 5 year under normal use.
For Remote
Note: Shower Head is not restricted to a specific remote.
• If the touch function on the shower head is still working, then that is
the indication that the battery for the remote needs to be changed.
• Replace batteries in battery holder with Qty (1) 3v Lithium cell.
• Pull Remote Face (1) to separate the Remote Base (3) from
Remote Face (1). Unthread Cover (2) by turning counter
clockwise. Push Spring (5) back to release the battery.
Once the battery is replaced, Thread Cover (2) by turning it
clock wise. Install Remote Face (1) back onto Remote Base (3),
making sure that knob (4) aligns with the Remote Base (3) .
• Battery lifetime is approximately 5 year under normal use.
1
1
5
2
- 2 -
1
4
3
M965815 (8/17)
Advertisement
Table of Contents
