Power Cord - Extreme Networks Summit Summit1 Hardware Installation Manual

S I
AFETY NFORMATION
• This unit operates under Safety Extra Low Voltage (SELV) conditions according to
IEC 950. The conditions are only maintained if the equipment to which it is
connected also operates under SELV conditions.
• The appliance coupler (the connector to the unit and not the wall plug) must have a
configuration for mating with an EN60320/IEC320 appliance inlet.
• France and Peru only
This unit cannot be powered from IT† supplies. If your supplies are of IT type, this
unit must be powered by 230V (2P+T) via an isolation transformer ratio 1:1, with the
secondary connection point labeled Neutral, connected directly to ground.
P C
OWER ORD
• This must be approved for the country where it is used:
USA and • The cord set must be UL-approved and CSA-
Canada
• The minimum specification for the flexible cord is
• The cord set must have a rated current capacity of
• The attachment plug must be an Earth-grounding
Denmark • The supply plug must comply with section
Switzerland • The supply plug must comply with SEV/ASE 1011.
• If the power cord plug is unsuitable and must be replaced, you may find other
codings for the respective connections. Connect the power supply wires for the unit
according to the following scheme:
— Brown wire to the Live (Line) plug terminal, which may be marked with the
letter "L" or colored red.
— Blue wire to the Neutral plug terminal, which may be marked with the letter "N"
or colored black.
— Yellow/Green wire to the Ground plug terminal, which may be marked with the
letter "E" or the Earth symbol
A-2
certified.
2
No. 18 AWG (1.5 mm
3-conductor.
at least 10A.
type with a NEMA 5-15P (10A, 125V) configuration.
107-2-D1, standard DK2-1a or DK2-5a.
or colored yellow/green.
), Type SVT or SJT,
S S H I
UMMIT WITCH ARDWARE NSTALLATION
G
UIDE