Sanyo SPW-XR253GH56 Technical Data & Service Manual page 196

e Set the required new indoor unit's No. by pressing the
AIR FLOW
UNIT
FLAP
TIMER SET
SET
f Press the SET button.
UNIT No, SET DATA (0008) and
g If you made a mistake, press the CL button.
h Finally, press the TEST / CHK button.
i If you want to change the indoor unit address of the other R.C. No., follow the step a
1
to h in the same way.
1 2
3
4
5
MODE
R.C. No.
SET TEMP.
CODE No.
FAN SPEED
SETTING
SET DATA
CL
ON •
OFF •
TEST / CHK
Ex: UNIT No. 3-6: currently registered indoor unit address
Required new indoor No.8: SET DATA
*
In this case, UNIT No. 3 – 6 (current)
0364_M_I
changes from flashing to ON state.
SETTING
IV - 30
4. Service procedures
, ( ) button.
≠
3 – 8 (NEW : after pressing the
TEST / CHK button)
SM830080