4.
Push the rail straight toward the rear of the rack until the latch locks in place.
Figure 41 Installing the rear end of the rail
5.
For the front end piece, rotate the latch outward and pull the rail forward until the pins slide into the flange, and
release the latch to secure the rail in place.
Figure 42 Installing the front end of the rail
6.
Repeat the preceding steps to install the right rail assembly.
Secure the rail assemblies to the cabinet
Use the screws and washers to secure the rails to the cabinet.
About this task
The supplied screws and washers are used to secure the rail assemblies to the front and rear of the cabinet.
Note:
For square hole cabinets, install the supplied conical washer before installing the screw. For unthreaded
round hole cabinets, install only the screw without the conical washer.
Dell EMC VxFlex Ready Node Server Installation Guide
R840 Equipment Installation
85