Secure The Rail Assemblies To The Cabinet; Installing The Front End Of The Rail; Installing Screws - Dell EMC VxFlex Ready Node Installation Manual

R740XD Configuration Equipment Installation
Figure 27 Installing the front end of the rail
6. Repeat the preceding steps to install the right rail assembly.

Secure the rail assemblies to the cabinet

The supplied screws and washers are used to secure the rail assemblies to the front and rear of the cabinet.
About this task
Note: For square hole cabinets, install the supplied conical washer before installing the screw. For unthreaded
round hole cabinets, install only the screw without the conical washer.
Procedure
1. Align the screws with the designated U spaces on the front and rear rack flanges.
Ensure that the screw holes on the tab of the system retention bracket are seated on the designated U spaces.
2. Insert and tighten the two screws using the Phillips #2 screwdriver.
Figure 28 Installing screws
Dell EMC VxFlex Ready Node Server Installation Guide
62