Figure 8 B13 sliding rail assembly - 2U systems
1. B13 sliding rail (2)
2. velcro strap (2)
3. screw (4)
4. washer (4)
Install the rails
About this task
The rails are labeled left and right, and cannot be interchanged. The front side of each rail is labeled Left Front or
Right Front when viewed from the cabinet front.
Procedure
1.
Determine where to mount the system, and use masking tape or a felt-tip pen to mark the location at the front
and back of the cabinet.
Note:
Install the left rail assembly first.
2.
Fully extend the rear sliding bracket of the rail.
3.
Position the rail end piece labeled Left Front facing inward and orient the rear end piece to align with the holes
on the rear cabinet flanges.
4.
Push the rail straight toward the rear of the rack until the latch locks in place.
Dell EMC VxFlex Ready Node Server Installation Guide
R640 Equipment Installation
31