Wire Connections - Motorola IRRInet-XL Owner's Manual

3.6.1

Wire Connections

1. For the NEMA4 housing enclosure punch a hole in one of the perforated circles
at the bottom of the RTU housing and insert the wires through the opening.
For the NEMA4X housing enclosure use the existing holes located at the bottom
of the housing.
2. Connect the I/O wires used to the mating connector plug located at the front of
the module. Refer to Figure 3-12 for user connections.
3. Ensure that the plug with connections #1 - #3 is inserted in the TB of the module.
Pin No.
N o t e :
N o t e :
To comply with CE and FCC standards a ferrite
(p/n: FLN9448) must be clamped onto the I/O wires.
Refer to CHAPTER 6 for assembly instructions.
Signal Name
1 LINE
2 Ground
3 LINE
3-20