Motorola IRRInet-XL Owner's Manual page 36

Assembly Instructions:
1. Verify that the Portable Radio power cable (p/n: FKN4465) is connected to
the 'AUX' connector of the Power Supply Module.
2. Verify that the radio communication cable (FKN5953) is connected to the
radio on one end, and to the CPU module Port 3 at the other end.
3. If assembly is on the 3-slot metal chassis: attach the Portable Radio Antenna
Cable (p/n: FKN5752) to the radio, using the female adapter SMA-to-BNC
(p/n: 5880384G68), and the other end to the bottom of the RTU housing
enclosure.
4. If assembly is in the NEMA4 housing enclosure: attach the Portable Radio
Antenna Cable (p/n: FKN4464) to the radio, using the female adapter SMA-
to-SMA (p/n: 0980411L01), and the other end to the RTU housing enclosure.
Operation
Turn the radio On-OFF / Volume knob to the ON position.
N o t e :
N o t e :
Setting the radio volume level is insignificant. However, set the
volume knob to minimum, to save battery power in case of power
failure.
Removing The Portable Radio
To remove the radio from the RTU proceed as follows:
1. Turn off the DC power.
2. Disconnect the DC power and antenna cable from the radio.
3. Disconnect the communication cable.
4. Remove the screws securing the radio to its mounting bracket.
Installing The Portable Radio
To install the radio from the RTU proceed as follows:
1. Turn off the DC power.
2. Place the radio and secure the screw of the radio-mounting bracket to the
radio.
3. Reconnect the communication cable.
4. Reconnect the DC power and antenna cables to the radio.
2-20