Advertisement
Contents
Connections
Troubleshooting
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
o Power does not turn on / Power is turned off
Symptom
Power does not turn on.
0
Power automatically turns
0
off.
0
o LED is flashing
Symptom
Flashing red. (Flashes at
0
0.25 second intervals)
Flashing red. (Flashes at
0
0.5 second intervals)
0
Front panel
Display
Playback
Check whether the power plug is correctly inserted into the power outlet.
The sleep timer is set. Turn on the power again.
"AUTO STANDBY" is set. "AUTO STANDBY" is triggered when there is no operation for a set amount of
time. To disable "AUTO STANDBY", set "AUTO STANDBY" on the menu to "OFF".
The amplifier circuit in the unit has malfunctioned. Disconnect the power and contact the repair center.
Protection circuit activated due to a rise in internal temperature. Turn off the power, wait for the set to fully
cool down, then turn the power back on.
Core wires of two speakers are touching each other or a core wire is sticking out of the terminal and
touching the set's rear panel, activating the protection circuit. First unplug the power cord, then twist the
core wires tightly or terminate the speaker cables, then reconnect.
Rear panel
Settings
Cause / Solution
Cause / Solution
55
Remote
Tips
Appendix
Page
Page
Index
24
45
52
－
71
71
Advertisement
