Removal Of The Light Source Cover; Removal Of The Rear Cover - Barco DP2K SLP Series Service Manual
Hide thumbs
Also See for DP2K SLP Series:
- User and installation manual (175 pages) ,
- Safety & environmental information (13 pages)
Table of Contents
Advertisement
Removal and installation of the projector covers
22.1 Removal of the Light Source cover
WARNING: Switch off the projector prior to start with this procedure, unless otherwise specified in
the procedure.
Required tools
Flat screwdriver 7 mm
How to remove the Light Source House cover?
1.
Loosen the four captive screws (reference 1 Image 22-1) of the Light Source cover using a 7 mm flat
screwdriver.
2.
Remove the Light Source cover from the projector.
Image 22-1
22.2 Removal of the rear cover
WARNING: Switch off the projector prior to start with this procedure, unless otherwise specified in
the procedure.
Required tools
Flat screwdriver 7 mm
How to remove the rear cover?
1.
Loosen the four captive screws (reference 1 Image 22-2) of the rear cover using a 7 mm flat screwdriver.
2.
Remove the rear cover from the projector.
272
R5906848 /04
DP2K SLP Series
1
Advertisement
Table of Contents
Troubleshooting
