Spare Parts For Dp2K-Slp Series; Projector Block Diagrams - Barco DP2K SLP Series Service Manual

Pressing the Sleep button in Standby mode for 3 seconds puts the projector in Sleep mode. In case the
projector is processing the after cooling cycle then the projector goes in Sleep mode after finishing the after
cooling cycle.
Pressing the Sleep button in Sleep mode for 3 seconds will awake the projector. The status light will blink for a
few seconds (booting up all inactive boards) and then lights up continuously.
Enter or leave Sleep mode can also be done via 2 dedicated projector command (USB/Ethernet), or via two
predefined Macros (not editable) with GPIO of the Cinema Controller (not the GPIO of the ICMP), or via the
Communicator.
The projector always boots up in the same mode (E.g. Standby or Sleep) as it was switched OFF.
The Sleep button is disabled if the Light Source is on.

2.4 Spare parts for DP2K-SLP Series

Up to date information regarding spare parts for DP2K-SLP Series
Barco continuously improves its service procedures for the customer. Managing spare parts is one of the key
processes. The spare parts list is subject to change. No spare parts list is included in this manual to ensure
that no spare parts are ordered based upon outdated information. Up to date information regarding spare
parts, and much more, is available on Barco's web site http://www.barco.com. Go to myBarco log in and enter
your credentials. Select your market and product and click on the product page on Technical support. The
Spare parts tab becomes available.

2.5 Projector block diagrams

Signal Backplane diagram
1
8S/10S Laser Light Source
(see sheet 1 or 2)
P
Pump
2
Tail Light
R765310
R782202
Switched Mode
Power Supply
R7681041 - R7860037
B324437 is replaced by B3244373 in GarreS
LPS RELAY
25A
B3244373
Mains Filter
25A
B3058365
Mains Switch & Fuse
Image 2-8
In Harbin A-series
J 1 0 J12 J 2 6 0
J261
J262
J11 - AMB TEMP SENSOR
J16
J15
J18
J19
J18 - FANS LAMPSIDE / PUMP J15 - FANS LENSSIDE / PUMP
J802
J100 - J101
J799 J30
J100 - J101
Cinema Controller
R76810392 - R7860108
Engine
RED GREEN BLUE
Projection
Lens
J 5 3 J 5 2 J 5 1 J 5 0
YE OR BR RD
J263
DCI SECURITY
Signal Backplane
R7681040 - R7860036
J17 - LENS MOTORS
J281 - CATEYE
Projector ID
J102 - J103 - J104 - J105
J502
J102 - J103 - J104 - J105
R5906848 /04 DP2K SLP Series
General
Motorized Lens
Lens Shift U/D
Lens Shift L/R
Electronics Box
ICMP
R7681061
or alternatively:
TI ICP + HDSDI
R765582(5) +
R765534 - R782327
J502
Button Module
R7681044 - R7860042
21