Tail Control And Gyro Setup / 尾舵控制及陀螺儀設定 - THUNDER TIGER mini Titan V2 Series Instruction Manual

TAIL CONTROL AND GYRO SETUP / 尾舵控制及陀螺儀設定
It is recommended to use a Heading Hold Gyro. With a Heading Hold Gyro, you may not use the trim and the
revolution mixing function of tail control.
First, choose the length of the tail servo arm referring to the manual of the Gyro. You may try 10.5mm as
the starting setting. Then mount the servo arm for the moment and check the movement of the tail servo:
1. While giving the right rudder control, the servo arm should move forward.
2. Rotate the helicopter with your hand counterclockwise, the servo arm should move forward.
建議使用鎖定式陀螺儀來作為尾舵控制系統，可為您帶來使用與設定上的便利與可靠度。
首先，參考陀螺儀使用手冊來設定尾舵伺服機擺臂長度。建議您可以10.5mm作為初步設定長度。將擺臂固定於伺服機
上，並與尾舵拉桿連接。
1. 尾舵控制桿右舵指令，伺服機擺臂向前擺動。
2. 手持機體逆時針轉動，尾舵伺服機擺臂向前擺動。
After esuring of moving direction of tail servo, you have to mount the servo arm in the correct position.
Please reset the receiver power and do not move the helicopter. While the tail control stick and trim are
centered, mount the servo arm vertically. Next, two points may be your concern:
1. The traveling limit of the tail servo may not go beyond the mechanical movement.
2. The tail servo horn should be vertical while the tail rotor are at 0 pitch or with a little offset to the
right.(Referring to the drawing below)
確認尾舵伺服機作動方向後，即可將伺服機擺臂安裝於伺服機上。安裝時，記得重新開啟接收機電源且勿移動直昇機。
伺服機擺臂須以90°安裝（如圖示）。請確認擺臂位於中立點位置及下列兩點注意事項：
1. 尾舵最大行程量，勿超過尾舵機械行程量。
2. 尾舵伺服機擺臂在中立點時，尾舵螺距應為0°或稍偏向右舵（如圖示）。
Note
1. To find the traveling limit, you have to adjust the Gyro referring to its manual.
2. To adjust the pirouetting speed of the helicopter, please use the〝Travel Adjustment〞or the〝D/R &
EXP〞function.
注意事項
1. 您可參考陀螺儀說明書，確認尾舵最大行程量。
2. 調整尾舵自旋轉速，請使用行程設定功能（Travel Adjustment）或是（D/R＆EXP）功能調整。
All manuals and user guides at all-guides.com
90°
Rudder Servo
尾舵伺服機
-26-
Rudder Servo
尾舵伺服機