Table of Contents
Advertisement
Installation and Use
Installation and Air Supply Requirement
To Avoid Injury:
- Always wear eye protection when installing equipment.
- Keep the work area clean and uncluttered.
-
- Keep unauthorized personnel out of the work area.
-
- Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
-
- Train all operators in the safe and proper use of power tools.
-
tool
- Operators should report any unsafe condition.
-Tool
- Install tools in dry, indoor, non-flammable, and non-explosive environments only.
STANLEY "C"
STANLEY
The controller is designed for mounting to a stable surface or bracket by bolting it via the two flanged mounting holes.
Controller
PSI Qualifier
In general, the SUPPLY AIR line to power the ePro FSC controller is same line which is sufficient to run the tool being used. A supply
Qualifier
inlet
of compressed air that is filtered and dry is required. Please check the individual tool specification for air requirements. Most tool
PSI)
25 liters/second (50 SCFM)
specifications are based on 90 psi (6 Bar) for full range operation. However, the controller will operate below at any level as long as
the psi and scfm are sufficient for the tool to reach the required torque. The supply air hose should be a ½" (15mm) or 3/8" (10 mm)
inside diameter with no restrictions (fittings) smaller than 3/8" inside diameter. If the air pressure and volume are insufficient, the
performance of the tool will suffer and the full torque range of the tool will not be realized. If the controller does not receive sufficient
NOK
air volume, the tool may operate erratically and the controller will indicate a bad cycle or no change on the display.
lubricator
합니 . PSI Qualifier's bottom outlet port
Install the ePro FSC controller onto an airline with an air filter before the air inlet to the controller. If a lubricator is used, it can be
installed before the controller or between the controller and the tool. The lubricator must be a free flowing design and not smaller
meters (25 feet)
than 1/2" NPT. Some lubricators act as a check valve and will not allow air flow "back" thru the lubricator. This type is not
10mm (3/8")
recommended for use with the ePro FSC.
합니 .
The tool air hose/cable for the EITP, EITM and ESPT series of tools is called the GEMINI. The GEMINI air hose includes an integral
transducer cable and is available in 3/8" I.D., coiled or straight and available in many lengths. A separate transducer cable is also
available. Prevent any unnecessary restrictions, elbows, swivels, etc between the controller and the tool to prevent air flow (scfm)
restrictions.
To Avoid Injury:
Shutoff
- Shutoff valve must be in the closed position until the air lines are installed and properly terminated.
-
- Do not connect power to the ePro FSC Controller until all air line connections are secured.
- Supply air energizes the outlet port when electrical power is supplied to the ePro FSC Controller.
-
6
Mounting Dimensions
2
inlet port
.
.
PSI Qualifier
합니 .
PSI Qualifier
PSI Qualifier
W A R N I N G
.
.
.
Typical Assembly
Line Installation
.
. Shut-off
.
tool
tool
.
W A R N I N G
outlet port
.
.
.
.
, Qualifier
. PSI Qualifier
6.3mm (¼")
PSI Qualifier
합니 .
.
.
WWW . S IG MA- SIX.NET
.
.
6 Bar (90
tool
tool
Qualifier
7.5
(fittings)
tool
PSI-C
Advertisement
Table of Contents
