Table of Contents
Advertisement
1.4 Installation Instructions
To Avoid Injury:
•
Always wear eye and foot protection when installing equipment.
•
Only use equipment and accessories specifically designed to operate with Stanley assembly
tools and use them only in the manner for which they are intended.
•
Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
•
Train all operators in the safe and proper use of power tools. Operators should report any
unsafe condition.
•
Store idle tools and accessories in a safe location accessible only by trained persons.
•
Disconnect power source (air, electricity, etc.) from tool prior to making adjustments, changing
accessories, or storing.
•
Prior to operation, always check and test tools and accessories for damage, misalignment,
binding or any other condition that may affect operation. Maintenance and repair should be
performed by qualified personnel.
•
Do not operate tools in or near explosive environments or in the presence of flammable liquids,
gases, dust, rain or other wet conditions.
•
Keep the work area clean, well lit and uncluttered.
•
Keep unauthorized personnel out of the work area.
DC Electric Tools & Controllers:
•
Install tools in dry, indoor, non-flammable, and non-explosive environments only – Humidity: 0
to 95% non-condensing and Temperature: 32 to 122 ºF (0 to +50 ºC).
•
Installation, maintenance and programming should be performed by qualified personnel.
Follow all manufacturer installation instructions and applicable regulatory electrical codes and
safety codes.
•
Tool and controller plugs must match the outlet. This equipment must be earth grounded.
Never modify a plug in any way or use any adaptor plugs.
•
Avoid body contact with electrically energized surfaces when holding a grounded tool
•
Prior to connecting a power source, always ensure the tool or controller is turned off.
•
Limit controller access to trained and qualified personnel. Lock controller cabinets.
To Avoid Injury:
•
Install modules in dry, indoor, non-flammable, and non-explosive environments only.
•
Qualified personnel should perform installation and programming. Follow all manufacturer
installation instructions, applicable regulatory electrical codes, and safety codes.
•
Limit module access to trained and qualified personnel. Lock module cabinets.
ELECTRICAL HAZARD
To Avoid Injury:
•
Install modules in dry, indoor, non-flammable, and non-explosive environments only.
•
Do not use this product near water, for example near a washbowl, wet basement, or the like.
•
This product should be located away from heat sources such as radiators or other devices that
produce heat.
•
This product should not be subjected to vibration or shock or in close contact with water or
other liquids.
•
To minimize electrical interference, place the module as far away from possible sources of
electrical noise, such as arc welding equipment.
4
W A R N I N G
W A R N I N G
W A R N I N G
User Manual
.
Advertisement
Table of Contents
