Table of Contents
Advertisement
Editing the Volume and Tonal Balance
(Mixer)
The "Panel" – "Audio" Part Selection tabs at the top of the Mixer display let you adjust the sound for each corresponding
part, while "Master" lets you make overall sound adjustments for the entire instrument.
NOTE
When an Audio Song is selected, you cannot set the parameters related to the Song part or channels.
NOTE
Knobs and sliders appear on the setting displays only when the relevant parameters are available.
For a visual indication of the signal flow and configuration of the Mixer, refer to the Block Diagram on
Filter
This function modifies the tonal characteristics (brightness, etc.) of the sound by cutting the output of a specific
frequency portion of the sound. This is not available when you select "Master" from among the tabs at the top of the
Mixer display.
Harmonic Content
Brightness
CVP-809/CVP-805 Reference Manual
Allows you to adjust the Resonance effect
combination with the "Brightness" parameter to add further character to the sound.
Determines the brightness of the sound for each part by adjusting the cutoff frequency
(page
49).
(page
49) for each part. This can be used in
page
17.
10
Hide quick links:
Advertisement
Table of Contents
