Epson PowerLite 9300i User Manual page 79

Enter up to four numeric characters for the time: press the
button on the remote control and then use the numeric keypad
buttons to enter a setting time within the range of 0 to 9999
hours, then press
Enter
press the button and re-enter the time.)
Esc
The time countdown starts after you finish using the Password
Protect menu.
4. To enable User's Logo Protect to prevent your custom A/V Mute
and power on screens from being changed:
Use the pointer button to highlight
then choose and press the
ON
5. To set your password, use the
, then press the
Password
6. When you see the message "Change the password?" select
and then press
Enter
7. The default setting for the password is "0000." Change this to
your own desired password: press the
control, then use the numeric keypad to enter a 4-digit number.
The password appears as
After you enter the last digit, you see a confirmation screen.
8. Re-enter the password that you entered in step 7.
If you enter the correct password, the message "The new password
is stored." appears.
If you enter the password incorrectly, a message prompting you to
re-enter the password appears. Select
button to re-enter your password.
9. When you finish entering your password, press the
10. Press the button on the remote control to cancel numeric
Num
keypad mode, if necessary. (Make sure the
turned off.)
11. Press the button to exit the password protection screen.
Menu
. (If you make a mistake entering the time,
User's Logo Protect
button to select it.
Enter
pointer button to highlight
button.
Enter
.
Num
on the screen.
* * * *
and press the
Yes
Num
Num
,
Yes
button on the remote
Enter
button.
Enter
button light is
Fine-tuning the Projector
note
If the length of time is set to
"0," the password entry
screen only appears when the
power is turned on the first
time after the projector has
been plugged in.
note
Make a note of your
password and keep it in a
safe place. Do not lose the
remote control. You must
use the remote to enter your
password.
79