Solving Problems With The Image Or Sound - Epson PowerLite 9300i User Manual

Solving Problems
112
Solving Problems with the
Image or Sound
You cannot turn on the projector.
If you're trying to turn on the projector using the remote control,
■
the remote control may be switched off (there's an on/off switch
on its side) or may be low on battery power. Try pressing the P
button on the projector instead.
Power
Make sure the power cord is properly connected, then wait for
■
the P power light to turn orange before pressing the P
button.
The P power light flashes green for about a minute as the
projector warms up, and then it remains green during normal
operation. (If the lights display a different pattern, see page 108.)
■ If you see a password protect screen, your projector has password
protection turned on. Press the
make sure it lights up), then enter your 4-digit password.
If you enter the wrong password three times, the projector will
become locked. Unplug the projector, plug it back in, turn it on,
then enter the correct password.
If you enter the wrong password nine times, the projector will not
turn back on again and you will need to contact EPSON.
If you forget your password or the projector becomes locked,
contact EPSON as described on page 118.
The projector is powered on, but not projecting an image.
■ Press the
A/V Mute
the picture has not been turned off temporarily.
The projector may be in sleep mode. If the P power light is
■
orange, press the P
The attached computer may be in sleep mode or displaying a
■
black screen saver. Try pressing a key on the computer.
button on your remote (and
Num
button on the remote control to make sure
button to turn on the projector.
Power
Power