BMW M 1000 RR 2021 Rider's Manual page 208

202 ACCESSORIES
Comply with the installa-
tion instructions supplied
with the optional accessory or
racing accessory.
Tightening the cable ties
has to be the last step in
the process; this is in order to
ensure that the wiring harness
can be positioned correctly and
that there is no strain on the
cable legs with plugs.
ATTENTION
Dirt and damp penetrating
inside open connectors
Malfunctions
Reinstall the cap or termin-
ating resistor, as applicable,
after removing the plug.
After removing the accessory:
Reinstall the cap or terminat-
ing resistor, as applicable.
Installing side panel (
with two-up riding package
Install the passenger seat
( 62).
Install the tail-hump cover
( 61).
Installing tail-hump trim panel
( 190).
USB CHARGING SOCKET
Notes on use
Charge current
This is a 5 V USB charging in-
terface that provides a max-
imum charge current of 2.4 A.
Automatic shutdown
The USB charging socket is
shut down automatically under
the following circumstances:
If battery charge state is too
low, to maintain the vehicle's
start capability.
If the maximum load capacity
as stated in the technical data
is exceeded.
During the starting operation.
Connection of electrical
devices
You can start using electrical
devices connected to the USB
charging socket only when the
188).
ignition is switched on. The
OE
power supply to the sockets
is switched off no more than
15 minutes after the ignition is
switched off, in order to pre-
vent overloading of the on-
board electrics.
BMW Motorrad recommends
using the BMW Motorrad
pouch for smartphone to
protect your smartphone
against water and vibration.