Integrated Management For Projector Status Check And Control (Emp Monitor); Registering Projectors To Be Monitored; Preparing The Pc - Epson PowerLite 8300i Software Manual

Integrated Management for Projector Status Check and Control (EMP Monitor)

EMP Monitor allows you to check the status of multiple projectors on the
network, switch them on or off, and switch between video sources
simultaneously. Up to 64 projectors can be monitored and controlled
simultaneously.
This projector A
Turn ON This projector
B
This projector C
System Configuration Example
TIP
You can monitor projectors even when they are in standby mode
(when the indicator light is lit orange ), but only if you have selected
"Advanced1" and "Standby Mode" from the projector's
configuration menu and if you have selected the "

Preparing the PC

Read the following notes before installing the EMP Monitor software.
• The EMP Monitor software must be installed on the network PC.
"EasyMP.net Software" in the EasyMP.net Setup Guide.
• The PC and projectors must be ready to be connected to the network.
Turn
projector B
ON
EMP Monitor
PC
" option.
• Only the administrator can start a PC running Windows 2000/NT4.0/XP
OS.

Registering Projectors to be Monitored

Use this procedure when you start EMP Monitor for the first time after
installation or when you register an additional projector. Once you have
registered the projector, the status of registered projectors will be displayed
automatically each time you start EMP Monitor.
PROCEDURE
Select "Start" - "Program" (or "All Programs") -
1
"EPSON Projector" - "EMP Monitor" in this order to
start EMP Monitor.
Click "Register projector".
2
EasyMP .net Operation Guide
39
Click to add a projector to
be monitored.