Projector Setup From The Pc (Easyweb); Before Operations; Starting Easyweb; Preparing The Projector - Epson PowerLite 8300i Software Manual

Projector Setup from the PC (EasyWeb)

A projector can be set up and operated using a Web browser through a
network connection.
This projector
Volume level down
System Configuration Example
Only the administrator or a user with sufficient access rights can access the
Change Setup page using a Web browser. Note that EasyConfiguration can
be accessed only by the administrator (or a user administrator rights).
Access rights can be assigned to a user by selecting "System Management"
- "Access Management" in EasyConfiguration (
TIP
You can set up and operate the projector using EasyWeb even when
the projector is in standby mode (when the indicator
but only if you have selected the "Advanced1" - "Standby Mode"
from the projector's configuration menu and if you have selected the
"Enable Network" option.
Volume is
lowered.
PC
p.18).
lis orange),

Before Operations

Preparing the Projector

Before using EasyWeb, check the following points.
- Prepare both the PC and the projector for connection to the network.

Operating Environment

Supported browser software:
Internet Explorer (Version 5.01 and higher)
* Set the screen resolution to 1024×768 pixels or higher, and set the
display colours to 256 colours or more.

Starting EasyWeb

PROCEDURE
Start your Web browser on the PC.
1
Enter the IP address
2
use in the Web browser, and connect.
TIP
If EMP NS Connection is installed, click "Display the projector
operation URL" on the toolbar.
Display the projector URL
EasyMP .net Operation Guide
of the projector you wish to
36