Advertisement
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included hex key, assembly requires a phillips screwdriver
spanners
, a rubber mallet
Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part
refers to the key number of the part, from the PART LIST on page 22. The number after the dash indicates the
quantity needed for assembly. Note: Some parts may have been pre-attached for shipping. If a part is not
in the parts bag, check to see if it has been pre-attached.
M8 Nylon
Locknut (38)–6
M4 x 16mm
Screw (52)–4
M8 x 45mm Button Bolt (50)–4
M10 x 74mm Button Bolt (27)–2
M10 Nylon
Locknut (33)–6
M4 x 19mm Flange
Screw (36)–6
, and a pair of pliers
M10 Split
Washer (59)–2
Washer (35)–2
M4 x 22mm
Screw (42)–2
Pedal Arm Bolt Set (40)–2
M10 x 75mm Carriage Bolt (34)–4
5
, two adjustable
.
M8.5
M10
Washer (55)–2
M8 x 19mm Shoulder
Screw (56)–2
Advertisement
