Problems With External Video Equipment - Epson MovieMate 55 User Manual

Problems with External Video Equipment

No picture appears on the screen.
■
Make sure the equipment is turned on.
■
Press the button on Epson MovieMate or on the remote control.
■
Press the or
■
Make sure you don't have cables connected to more than one video port. You can only
use one connection at a time (see page 22).
You see the message
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 22).
■
Press the button on Epson MovieMate or the remote control to select the external
video source. Allow a few seconds for Epson MovieMate to sync up.
You see the message
Press the button on the remote control and check the
page 40).
The picture is cut off (too large) or too small.
Press the button on the remote control and select the appropriate aspect ratio.
Press the button on the remote control and select the appropriate zoom setting.
The picture is distorted.
■
If you're using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 53 and 54.
The colors are not right.
■
Press the button on the remote control and check the
page 40).
■
Press the button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
button on the external equipment.
Play
.
No Signal
Signal not supported.
or settings. See page 38.
Tint
setting (see
Video Signal
setting (see
Video Signal
Problem Solving
55