Epson EX30 User Manual page 64

note
You can also use the remote
control's button to
Auto
automatically reset the
projector's Tracking, Sync,
and Position settings. See
page 93 for details.
note
You can adjust the
setting for
Progressive
signals from the HDMI
input port (excluding digital
RGB) or component video
only when 480i/576i/1080i
signals are being input
(EX70 only).
The HDMI Video Range
setting cannot be set for
digital RGB signals (EX70
only).
Fine-Tuning the Projector
64
■
Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■
Sync
Adjust this value if computer images appear blurry or flicker.
■
Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the arrow
buttons to center it.
■
Progressive
For composite video, S-Video, component video, and certain
signals from the HDMI port only (EX70 only). Turn this
setting on to convert interlaced signals into progressive signals
(best for moving images). Leave the setting
images.
■
HDMI Video Range
When you connect to the HDMI input port, set the
projector's video range to match the video range setting of
your device.
■
Input Signal
If the colors don't look right on the
setting for the type of equipment you've connected to the
Computer (Component Video)
computer or RGB-video connection, or
player that outputs a component video signal (with
connectors labeled Y/Cb/Cr or Y/Pb/Pr).
(composite or S-Video signals only)
■ Video Signal
Select the setting for the type of equipment you've connected
to the port. Leave this setting at
Video
using a 60-Hz PAL system (then select
■ Aspect
Sets the image's aspect ratio (ratio of width to height). See
page 47 for more information.
Off
(EX70 only)
setting, select the
Auto
port. Choose
Auto
Auto
PAL60
for still
for a
RGB
for a video
unless you are
).