Table of Contents
Advertisement
FM Racer configuration files use the *.FMCONF file extension.
If the unit is not connected to the Internet, you can still use the FM Racer
configuration interface to define a configuration file, then upload it to the
unit. This can be done in either of two different ways:
• A range of ready-made configuration templates are available from
the FM Racer interface. Each template caters to a particular
configuration scenario, and can be copied and modified to your
needs.
• Alternatively, you can create a new, custom configuration template.
For instructions on how to copy, modify or create a configuration template
using the FM Racer interface, refer to the Cisco Networks FM RacerUser
Manual.
A configuration file that has been created using the FM Racer interface
must be uploaded to the unit. To upload a FM Racer configuration file, do
the following steps:
1.
Switch the unit to Offline mode as shown in
offline and online modes" (page
2.
Click the
• The Configurator landing page will be shown.
3.
Click the Choose File button in the Upload Configuration File
section
Figure 22. Configurator interface (FM Racer configuration file
upload dialog)
• Find and choose the correct configuration file by following
the software prompts.
4.
Click the
• The configuration file will be uploaded and applied to the
unit.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
-RACER™ link in the left-hand settings menu.
(Figure 22 (page
69)).
Upload Configuration button.
"Switching between
67).
Page 69 of 189
Advertisement
Table of Contents
