Table of Contents
Advertisement
4.
To show the password as it is being typed, check the Show
Password check-box.
5.
Save the Viewmode Credentials settings by clicking the Change
button. Alternatively, clear the settings by clicking the Reset
button.
To change the View Mode settings, do the following steps:
1.
Log in to the unit's Configurator GUI with Administrator
credentials. See
configuration" (page 57)
2.
Click the -view mode settings link under MANAGEMENT
SETTINGS in the left-hand settings menu
Figure 55. Configurator GUI (VIEW MODE SETTINGS dialog)
• The VIEW MODE SETTINGS dialog will be shown.
3.
To allow or prohibit access to any device-configuration settings,
click the relevant drop-down, and click the Disabled or Enabled
setting:
• If the Disabled option is selected for a device-configuration
setting, the setting for that category will be visible but not
accessible to ordinary users.
• If the Enabled option is selected for a device-configuration
setting, the setting can be modified by ordinary users.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Accessing the Cisco FM4200 Fiber for device
for more information.
(Figure 55 (page
141)).
Page 141 of 189
Advertisement
Table of Contents
