Table of Contents
Advertisement
2.
Do a local (offline) configuration using the Configurator interface.
For further information, refer to
configurator interface" (page
For a quick overview of the initial configuration process, refer to the
flowchart below.
NOTE
Each individual Cisco radio transceiver unit has a factory-set
mesh identification number that takes the form 5.w.x.y.
If the unit's IP address is set to 169.254.x.y/24 as in Case 2
below, the values x and y represent parts x and y of the unit's
mesh identification number.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Device configuration using the
55).
Page 66 of 189
Advertisement
Table of Contents
