Table of Contents
Advertisement
No.
Part name
1. Detachment
7
Heat
exchanger
NOTE :
Recover refrigerant gas and then remove
the refrigerant piping of the indoor
unit.Remove the indoor unit and carry out
the work on the floor. etc.
1) Remove the drain pan.(Refer to No. 3 )
Remove TC1 sensor, TC2 sensor and TCJ
sensor from the sensor holder.
Remove the relay connector of PMV lead wire
in the electric parts and then pull off it from
the bushing.
2) Remove the check port cover (A).
3) Take off fixing screw and remove cover (B).
4) Take off the heat exchanger fixing screws
5) Take off screws which fix the main unit
Procedure
(Refer to No.
6
)
(2 positions) which fix the side plate (Left)
and the heat exchanger.
(Front side) and the heat exchanger to
remove the heat exchanger.
Side plate (Left)
Main unit (Front side)
– 78 –
Remarks
Check port cover (B)
Check port cover fixing screws
Heat exchanger fixing screws
Heat exchanger fixing screws
(Front side)
Advertisement
Table of Contents
