Table of Contents
Advertisement
Changing of settings for Celsius display
ON / OFF
• Push
button if the unit stops.
1
Procedure
TEST
Push simultaneously
After a while, the display part flashes as shown right. Check the displayed CODE No. is [
• When the CODE No. is other than [
first step. (After pushing
(For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
2
Procedure
UNIT LOUVER
Every pushing
button (button at left side), the indoor unit No. in the
group control
is displayed in order. Select the indoor unit of which setup is changed.
In this time, the position of the indoor unit of which setup is changed can be
confirmed because fan and louver of the selected indoor unit operate.
3
Procedure
1. Using temp. setup
33
(CODE No. [
]: Fahrenheit display)
TIME
2. Using timer
buttons, change the line address from [
0000
[
. ]
SET
3. Push
button. In this time, the setup finishes when the display
changes from flashing to lighting.
4
Procedure
After check of the changed contents, push
TEST
When pushing
button, the display disappears and the status becomes the usual stop status.
TEST
(When pushing
button the operation from the remote controller is not accepted for approx. 1 minute.)
• If the operation from the remote controller is not accepted even 1 minute or more passed after pushing
button, it is considered that the address setup is incorrect. In this case, the automatic address must be again
set up.
When changing the settings from Celsius to Fahrenheit indication, follow to the reverse order of the above
procedure.
CL
+
SET
+
buttons for 4 seconds or more.
10
], push
TEST
button, operation of the remote controller is not accepted for approx. 1 minute.)
4
5
6
1
TEMP.
buttons, specify CODE No. [
TEST
button. (Setup is determined.)
TEST
button to erase the display and repeat procedure from the
33
].
0001
] to
– 44 –
10
].
3
2
SET DATA
SETTING
UNIT No.
R.C.
No.
SET DATA
SETTING
UNIT No.
R.C.
No.
SETTING
CODE No.
CODE No.
TEST
Advertisement
Table of Contents
