Assembly - NordicTrack Incline Trainer X7i User Manual

ASSEMBLY

• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• The underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
1. Make sure that the power cord is unplugged.
With the help of a second person, tip the incline
trainer onto its left side. Have the second per-
son hold the incline trainer to prevent it from
falling.
Attach four Base Feet (10) and four Base Foot
Spacers (11) to the Base (80) with four #8 x 1"
Tek Screws (2) in the locations shown. Be care-
ful not to overtighten the Tek Screws.
All manuals and user guides at all-guides.com
8
• To identify small parts, see page 7.
• Assembly requires the following tools:
the included hex keys
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
11
10
2
10
2
11
11
10
2
11
10
2
80