H38 Designer River Rocks Installation; H42 Designer River Rocks Installation - Montigo HL34 Installation & Maintenance Manual

H38 Designer River Rocks Installation
STEP 1: Install the new Rock Tray and front cover. Make sure the
tray is not sitting on top of the pilot.
ROCK TRAY
FRONT COVER
Figure 26. H38DF*'s Fireplace Base.
STEP 2: Slide the rock guard locator tabs behind the Burner. The
rocks on the Rock Guard should line up between the air
inlets of the burner.
STEP 3: Install Rear faux "A" ceramic 3 in1 Rock. Install Lower (17)
seventeen Faux Rock "B"
FAUX ROCKS B
STEP 4: Install the Upper (8) eight Faux Rock "C" Note: place cut
surfaces of Rocks face down on lower Rocks.
STEP 5: Next step, install the Front (3) three Center Front Faux
Rocks "D"
XG0228 - 021419
Figure 26.b
FAUX ROCK A
Figure 26.c
Figure 26.d
H42 Designer River Rocks Installation
STEP 1: Install the new Rock Tray and front cover. Make sure the
tray is not sitting on top of the pilot.
ROCK TRAY
FRONT COVER
Figure 27. H42DF*'s Fireplace Base.
STEP 2: Slide the rock guard locator tabs behind the Burner. The
rocks on the Rock Guard should line up between the air
inlets of the burner.
STEP 3: Install Rear faux "A" ceramic 3 in1 Rock. Place the (4) four
centre faux rocks "B" on the riser spikes. faux rock C on Pilot cover.
FAUX ROCK C
FAUX ROCKS B
STEP 4: Place (18) eighteen faux rocks "D" as shown below.
STEP 5: Place three faux rocks "E" (shown circled). Place eleven
faux rocks "F" (shown as squares)
Installation
Figure 27.b
FAUX ROCK A
Figure 27.c
Figure 27.d
39