Dukane DVP510A User Manual page 56

9 The images
outputted from
DVP510A are too bright,
dark or vague
10 Unable to record
images
11 The operating steps
in the manual are not
applicable to the
machine
12 Unable to login to the
network control page
Continuous mode or the time for capture is set to be
long. For the related setting, refer to
to capture images of Chapter 7 Descriptions of
major functions.
Press [AUTO TUNE] to automatically adjust to the optimal
brightness and focal length.
1. Check to see if the stored data have reached the
maximum size of the USB disk (priority) or internal
memory.
2. Please confirm the rotation angle. You may not able to
record when the image is rotated by 90°/270°.
The operating steps in the manual may be not
applicable to the machine due to improvement in
functions.Check to see if the Firmware version of your
machine is up-to-date.
1 Please go to Dukane official website to check whether
the latest version is available for update.
http://www.dukaneav.com
2 The steps to check the FW version are as below:
2.1 Press [MENU] on the remote control or control
panel to enter the setting menu.
2.2 Press [] or [] to select [Advanced] menu.
Firmware
version
If you are not sure whether it is the latest version,
please consult your dealer for advice.
http://www.dukaneav.com .
If DHCP is enabled, the IP address may not be updated.
Please follow the steps below:
1 Press [MENU] on the remote control or control panel
to enter the setting menu.
2 Press [] or [] to the [Advance] menu.
3 Press [] or [] to the [Ethernet].
4 Press [ENTER] to open the Ethernet OSD menu.
5 Press [] to find [DHCP].
6 Press [ENTER] to modify it.
7 Press [] or [] to select [On].
Master: PVC039 Slave: PVD035
7.11 I would like
English - 55