Inspection - MULTIQUIP Whiteman PRO Series Operation Manual

ENGINE OIL
1. Place the trowel on secure, level ground with the
engine OFF.
2. Remove the dipstick (Figure 30) from the engine oil
filler hole and wipe it clean.
Figure 30. Engine Oil Dipstick
3. Reinsert the dipstick, then remove it again without
screwing it into the filler neck. Check the oil level shown
on the dipstick.
4. If the oil level is low (Figure 31), fill to the edge of the
oil filler hole with the recommended oil type as listed
in Table 5. Refer to Table 2 for maximum engine oil
capacity.
Figure 31. Engine Oil Dipstick (Oil Level)
Table 5. Oil Type
Season Temperature
Summer 25°C or Higher
Spring/Fall 25°C–10°C
Winter 0°C or Lower
PAGE 32 — PRO SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (9/21/17)
DIPSTICK
UPPER LIMIT
LOWER LIMIT
Oil Type
SAE 10W-30
SAE 10W-30/20
SAE 10W-10
FUEL
Remove the fuel filler cap and inspect the fuel level in the
tank. If fuel is low, replenish with unleaded fuel.
DANGER
Motor fuels are highly flammable and
can be dangerous if mishandled. DO NOT
smoke while refueling. NEVER attempt to
refuel while the engine is running or hot!
WARNING
ALWAYS use a strainer for filtration while refueling.
NEVER top off fuel. ALWAYS wipe up any spilled fuel
immediately.
GEARBOX OIL
1. Look at the sight glass on the side of the gearbox
(Figure 32) to determine if gearbox oil is low. The
correct oil level is to the halfway point on the sight glass.
GEARBOX
Figure 32. Gearbox Oil
2. If gearbox oil is low, remove the drain/fill plug
(Figure 32) and fill with Mobil SHC™ 634 industrial
synthetic gear oil until the correct oil level is reached.
Replace the drain/fill plug when finished.
3. If there is too much oil in the gearbox, remove the
drain/fill plug and allow the oil to seep out. Replace the
plug once the correct oil level is reached.

INSPECTION

SIGHT GLASS
DRAIN/FILL
PLUG