Airflow Rate; Airflow Direction - Daikin CTXJ25TVMAW Operation Manual

1. Press
one or more times to select the operation mode.
Result: The mode will be set as follows:
2. Press to start operation.
Result: and the selected mode are displayed on the LCD.
3. Press or one or more times to lower or raise the
temperature.
Cooling Heating
operation operation
18~32°C 10~30°C
Note: When using drying or fan only mode, you cannot adjust
the temperature.
4. Press to stop operation.
Result:
disappears from the LCD. The operation lamp
goes off.

4-3-2 Airflow rate

1. Press
to choose:
5 airflow rate levels, from " " to " "
Automatic operation
Indoor unit quiet operation. When the airflow is set
to " ", the noise from the unit will be reduced.
Note: When using drying operation mode, you CANNOT adjust
the airflow rate setting.
To adjust the airflow rate
1. Press
to change the airflow setting as follows:

4-3-3 Airflow direction

When. Adjust the airflow direction as desired.
What. The system directs the airflow differently, depending
on the user selection (swinging or fixed position). It does so by
moving horizontal blades (flaps) or vertical blades (louvres).
Setting
Moves up and down.
Vertical automatic
swing
Moves from side to side.
Horizontal
automatic swing
Moves simultaneously up and down
+ 3-D airflow
and from side to side
direction
[—]
Stays in a fixed position.
Automatic Drying or Fan
operation only operation
18~30°C —
Airflow direction
CAUTION
• ALWAYS use a remote controller to adjust the position of the
flaps and louvres. When the flaps and louvres are swinging
and you move them forcibly by hand, the mechanism will
break.
• Be careful when adjusting the flaps and louvres. Inside the
air outlet, a fan is rotating at high speed.
Note: The movable range of the flap varies according to the
operation mode. The flap will stop at the upper position when
the airflow rate is changed to low during the up and down swing
setting.
b
a
a Flap range in cooling or drying operation
b Flap range in heating or fan only operation
To adjust vertical airflow direction
1. Press .
Result:
appears on the LCD. The flaps (horizontal
blades) will begin to swing.
2. To use fixed position, press
the desired position.
Result:
disappears from the LCD. The flaps will stop
moving.
To adjust horizontal airflow direction
1. Press
.
Result:
appears on the LCD. The louvres (vertical
blades) will begin to swing.
2. To use fixed position, press
the desired position.
Result:
disappears from the LCD. The flaps will stop
moving.
To use 3-D airflow direction
1. Press and
Result: and appear on the LCD. The flaps (horizontal
blades) and louvres (vertical blades) will begin to swing.
2. To use fixed position, press
flaps and louvres reach the desired position.
Result: and disappear from the LCD. The flaps
and the louvres will stop moving.
when the flaps reach
when the louvres reach
.
and when the
8