To Operate The Remote Controller; Before Operation; To Fix The Remote Controller To The Wall; To Insert The Batteries - Daikin CTXJ25TVMAW Operation Manual

Comfort operation is active
Intelligent eye is active
Automatic vertical swing is active
Automatic horizontal swing is active
Streamer is active
Icon
ON timer is active
OFF timer is active
Weekly timer is active
Day of the week
Current time

2-2-3 To operate the remote controller

a
≥500
(mm)
a Signal receiver
Note: Make sure that there are no obstacles within 500 mm
under the signal receiver. They may infl uence reception
performance of the remote controller.
1. Aim the signal transmitter at the signal receiver on the
indoor unit (maximum distance for communication is 7 m).
Result: When the indoor unit receives a signal from the remote
controller, you will hear a sound:
Sound
Beep-beep
Beep
Long beep

3. Before operation

3-1 To fi x the remote controller to the wall
a b c
a Remote controller (Accessory)
b Screws (Accessory)
c Remote controller holder (Accessory)
5
Description
Description
Operation starts.
Setting changes.
Operation stops.
1. Choose a place where the signals reach the unit.
2. Attach the holder with screws to the wall or a similar location.
3. Hang the remote controller on the remote controller holder.

3-2 To insert the batteries

CAUTION
Incorrect handling of batteries can result in injury
from battery leakage, rupturing or heating, or lead to
equipment failure.
Please observe the following precautions and use safely.
• If the alkaline solution from the batteries should get in the
eyes, do not rub the eyes. Instead, immediately fl ush the
eyes with tap water and seek the attention of a medical
professional.
• Keep batteries out of reach of children. In the event that
batteries are swallowed, seek the immediate attention of a
medical professional.
• Do not expose batteries to heat or fi re. Do not disassemble
or modify batteries. The insulation or gas release vent inside
the battery may be damaged, resulting in battery leakage,
rupturing, or heating.
• Do not damage or peel off labels on the batteries.
1. Slide the front cover to take it off.
2. Insert 2 dry batteries AAA.LR03 (alkaline).
3. Replace the front cover.
2
Position
3
1
Grip both sides
of the front
cover.
Note: To avoid possible injury or damage from battery leakage
or rupturing, remove the batteries when not using the product
for long periods of time.
The standard replacement time is about 1 year. Both batteries
should be replaced at the same time. Be sure to replace them
with new dry batteries AAA.LR03 (alkaline).
When battery power has run out, the LCD will begin blinking as
an alert that the batteries need replacing. In some cases, when
battery consumption is accelerated owing usage conditions,
signal reception may decline before the LCD begins blinking.
The batteries supplied with the remote controller are for initial
operation. The batteries may run out in less than 1 year.

3-3 Clock

If the indoor unit's internal clock is NOT set to the correct time,
the ON timer, OFF timer and weekly timer will NOT operate
correctly. The clock must be set again:
• After a circuit breaker has turned the unit OFF.
• After a power failure.
• After replacing batteries in the remote controller.
and
correctly!