Changing Group 4 Default Settings - Epson FX-870 User Manual

Changing Group 4 default settings

Group 4 default settings differ from 1 to 3. You determine the setting
by the number of beeps you hear instead of checking the panel
lights. Also, the printer does not print a list of Group 4 default
settings. To change Group 4 default settings follow the steps below.
1. Make sure the printer is turned off.
2. Hold down the
on the printer. You then enter the Group 4 default-setting mode.
3. FONT, PAUSE,
Press the
change the current setting. The printer beeps once or twice to
indicate your setting.
Button
PAUSE
PAPER FEED
FONT
For example if you press the
becomes invalid and the printer beeps once.
Note:
If you don't press any button within a few seconds after
l
entering this mode, the printer beeps five times and
automatically exits the Group 4 default-setting mode, leaving
the settings unchanged.
Once you change a feature's setting, you cannot change it
again without first exiting and re-entering the Group 4
default- setting mode.
4. After you make your changes, wait until the
on. This shows that the printer has automatically exited the
setting mode and you can begin printing.
3-14 Using the Printer
PAUSE PAPER FEED
and
PAPER FEED
or
Feature
Input buffer
Draft print speed
Auto carriage return
PAUSE
Default-Setting Mode
buttons while you turn
button if you want to
Settings
Valid
Invalid
High
Normal
Valid
Invalid
button, the input buffer
READY
light comes
Beeps
Twice
Once
Twice
Once
Twice
Once