Epson AcuLaser C8500 Quick Reference Manual page 18

Messages Description
The printer has insufficient memory
to execute the current task.
Printouts are not output to the
specified output tray but to another
tray due to a printing restriction.
: The selected paper source is
indicated.
: The selected paper size is
indicated.
There is no paper in the specified
paper source (XXX). Load paper of
the indicated size (YYY) into the
paper source.
: The selected paper source is
indicated.
: The selected paper size is
indicated.
The paper loaded in the specified
paper source (XXX) does not match
the required paper size (YYY).
Replace the loaded paper with the
correct size paper and press
Continue.
If you press Continue without
replacing the paper, the printer will
print on the loaded paper even
though it does not match the
required size.
Messages Description
The installed photoconductor unit
has a problem. Turn off the printer,
remove the photoconductor unit
and install a new photoconductor
unit.
The required time to process the
print data exceeds the print engine
speed because the current page is
too complex. Press the Continue
button to resume printing. If this
message appears again, turn on
Config Menu.
If you continue to receive this
message when printing a particular
page, try simplifying the page by
limiting the number of graphics or
reducing the number and size of
fonts.
The writing of PostScript 3
commands on the optional Hard
Disk Drive is no longer possible as
the amount of space allocated to
PostScript 3 on the Hard Disk Drive is
used up.
in the SelecType
18 18 18 18