Table of Contents
Advertisement
Figure 29. Cable routing for server models with eight 2.5-inch hot-swap drives (hardware RAID)
Cable
From
Power cable
Power connector on the backplane
1
SAS signal cable
SAS 0 and SAS 1 connectors on the
2
backplane
Server models with sixteen 2.5-inch hot-swap drives (hardware RAID)
Use this section to understand the cable routing for server models with sixteen 2.5-inch hot-swap drives
(hardware RAID).
Notes:
• There are two types of configurations:
– Two 8i RAID adapters
– One 16i RAID adapter
• Ensure that all cables are routed through the correct cable clips.
ThinkSystem ST250 Setup Guide
44
To
Backplane 1 power connector on the system
board
Connectors on the RAID adapter
Advertisement
Table of Contents
