Operation
EMU40583
Checking power trim and tilt unit
EWM02523
WARNING
Never get under the lower unit while it
is tilted, even when the tilt support
shaft is installed. Severe injury could
occur if the outboard motor accidental-
ly falls.
Body parts can be crushed between the
outboard motor and the clamp bracket
when the outboard motor is trimmed or
tilted.
Make sure that no one is near the out-
board motor before performing this
check.
1.
Check the power trim and tilt unit for fluid
leakage.
2.
Operate each of the power trim and tilt
switches on the bottom cowling and re-
mote control lever to check that all
switches work.
54
UP
DN
1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
3.
Tilt the outboard motor up and check
that the tilt rod and trim rods are extend-
ed completely.
ZMU06969
1
2
1. Tilt rod
2. Trim rods
4.
Check that the tilt rod and trim rods are
1
ZMU06907
ZMU06981
ZMU06923