Main Switch; Power Trim And Tilt Switch On Remote Control; Power Trim And Tilt Switch On Bottom Cowling - Yamaha VF200 Owner's Manual

EMU26091

Main switch

The main switch controls the ignition system;
its operation is described below.
" (off)
"

With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
" (on)
"

With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
" (start)
"

With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
ON
OFF
OFF
EMU32053
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
" (off) posi-
" (on) posi-
" (start) po-
" (on) position.
START
ZMU06245
ON
START
ZMU07019
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Push-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 61 and 63.
UP
DN
1
1. Power trim and tilt switch
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch " " (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 63.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
Components
" (up) trims the
ZMU06981
"
27