Receiving Faxes - Epson Stylus CX6900 User Manual

Setting or adjusting resolution and
contrast
If you want to set or adjust resolution, follow the
steps below.
1. Press the [ Fax] button until you see this
screen.
1.Resolution
2. Press the x OK button.
3. Press the u or d button to select resolution.
4. Press the x OK button. You return to
1.Resolution.
5. Press the y Stop [y Cancel/Back] button until
you return to the first screen.
If you want to set or adjust contrast, follow the steps
below.
1. Press the [ Fax] button until you see this
screen.
2.Contrast
2. Press the x OK button.
3. Press the u or d button to select contrast.
4. Press the x OK button. You return to 2.Contrast.
5. Press the y Stop [y Cancel/Back] button until
you return to the first screen.

Receiving Faxes

The product automatically receives and prints faxes
in Auto Answer mode. However, you may want to
receive faxes manually if you connected the product
and a phone or answering machine to a phone line
that also receives voice calls. Then you can check for
a fax tone from the sending fax machine and press a
button on the product to receive the fax, or allow
your answering machine to determine if the call is an
incoming fax.
Note:
Make sure you selected the Paper Size setting that matches the
size of paper you have loaded. If the incoming fax pages are larger
than the paper size you loaded, the fax size is reduced to fit or
printed on multiple pages, depending on the Automatic Reduction
setting you select (& "Selecting send/receive settings" on page 9).
14
Faxing a Photo or Document
Selecting the answer mode
This product tells you whether Auto Answer is
turned on or not on the first screen:
21:00
Y: Auto Answer is turned on
21:00
N: Auto Answer is turned off
To change the answer mode, press the
Answer] button. The Y or N changes on the first
screen. Press the [Auto Answer] button again to
change it back.
Note:
You can select the number of rings that must occur before the
product receives a fax using the Rings to Answer setting
(& "Selecting send/receive settings" on page 9).
Receiving a fax
When the product receives a fax with Auto Answer
mode turned on, the message Printing appears on the
LCD screen.
When the product receives a fax in manual answer
mode, the connected phone begins ringing. Once you
answer the phone to confirm that the call is a fax,
press x Start D [x Start B&W] or x Start E [x Start
Color] button to receive the fax. The message
Printing appears on the LCD screen.
Note:
You cannot choose the color to print the fax data. It depends on
the settings made by the sender.
After the product receives all the pages, it begins
printing the fax. When it is finished, you see the first
screen.
Note:
If you run out of paper during printing, an error message informs
you that there is no paper in the sheet feeder. Load more paper
and press the x OK button to continue printing. If you see any
other error messages, see & "Error Messages" on page 31.
Y
N
[Auto